Flywoo BNF Firefly DC16 Nano Baby HD V2.0 1S 1.6″ Deadcat Micro Quad w/ HDZero Whoop Lite & Nano Lite Cam – ELRS 2.4 GHz

Check out our other pre-built quads, as well as other great products from Flywoo!

Features

• Redesigned canopy with enhanced aesthetics and reinforced camera protection.
• The bottom plate is thicker and has extended motor protection corners, resulting in a more stable and durable quadcopter.
• Equipped with ROBO 1002 19800KV motor and 1608 3-bladed 40mm propellers, delivering a 30% increase in power, reduced noise, and enhanced flight stability.
• The GOKU Versatile F411 ELRS 1S AIO V2 boasts an ELRS 2.4G receiver, expertly connected via UART 2 instead of SPI for superior performance.
• A30 plug supports a continuous current of 15A, providing greater power and longer flight times compared to the PH2.0 connector.
• New battery compartment design allows for easy replacement of batteries of different models.

Dead Cat Style

New Design

Redesigned canopy with enhanced aesthetics and reinforced camera protection.
Bottom plate is thicker and has extended motor protection corners, resulting in a more stable and durable quadcopter.

Efficient Power Combo

Equipped with ROBO 1002 19800KV motor and 1608 3-bladed 40mm propellers, delivering a 30% increase in power, reduced noise, and enhanced flight stability.Ultra-light AIO with ELRS 2.4G RX
The drone’s GOKU Versatile F411 VTX 1S AIO V2 includes a built-in 250mW video transmitter, enabling an extended flight range and ultimate lightweight design without sacrificing performance, with improved circuit board stability.

HD Digital VTX System

The HDZero Nano Lite Camera is a revolutionary product designed for lightweight drones, weighing only 1.5g and combined with the new Whoop Lite VTX at 4.5g. Supporting 1-3S power input, it can record in 720P/60FPS with ultra-low latency of less than 19ms and features OSD function configuration through Betaflight Configurator.

More Power, More Flight Time

The A30 plug can sustain a continuous current of 15A, whereas the PH2.0 connector can only support 4.5A. Given the same capacity, the A30 plug can release more current, providing greater power and, as a result, longer flight times even when flying at full speed. 

Specifications

• Frame Kit: Firefly 1S DC16 Nano baby quad Frame kit
• Motor: ROBO 1002 19800KV
• Electronic: GOKU Versatile F411 ELRS 1S 5A AIO V2.0
• Propeller: 1608-3 Blade 40mm 1.5mm Shaft
• Camera: Nano Lite Cam
• Weight: 31g

GOKU Versatile F411 ELRS 1S 5A AIO V2.0
Flight Controller

• MCU: STM32F411CEU6
• GYRO: ICM42688
• UARTS: 1/2
• Soft serial port: 1
• I2C: SCL/SDA
• BEC: 5V
• Input Voltage: 1S (<4.35v)
• Firmware: FLYWOOF411_5IN1_AIO 
• Mounting:  25x25mm, M2

Onboard 4in1 ESC

• MCU: EFM8BB21
• Power supply: 1S LiPo/LiPo HVCurrent: 5A
• Firmware: BLHeli_S
• Factory firmware: O_H_5_REV16_8.HEX
• Default protocol: DSHOT 150/300/600
• ELRS 2.4G RX (UART2)

ROBO 1002 19800KV

• Configuration: 9N12P
• Stator Diamter: 10mm
• Stator Length: 2mm
• Shaft Diameter: 1.5mm
• Motor Dimension(Dia.xLen): Φ13.5×7.75mm
• Weight(g): 2.5(5cm wire)
• Idle current(5)@5V(A): 1.3
• No.of Cells(Lipo): 1S
• Max Continuous Power(W)3S: 44
• Internal Resistance: 89mΩ
• Max Current(3S): 11.8A
• Max Efficiency Current: (2-4A)>84%

HDZERO WHOOP LITE VTX

• Input Voltage: 1S-3S
• Output Power: 23mW, 200mW
• Operating Frequency: 5.727-5.850GHz
• Resolution: 1280×720@60fps
• Power Consumption: 5W @ 25mW, 5.8W @ 200mW
• MSP Canvas Mode: Yes
• Antenna Interface: U.FL (IPEX 1)
• Operating Temperature: 32-104°F
• Mounting Pattern: 25x25mm, M2
• Weight: 7g total package

HDZERO NANO LITE CAMERA

• Size: 14x16x11mm
• Weight: 1.5gram
• Sensor: 0.5 inch, up to 10650 mV/Lux-sec
  Ultra-high sensitive CMOS sensor
• FOV:
  – 4:3 D:130° H:108° V:84°
  – 16:9 D:122° H:108° V:65°

Includes

• 1x Flywoo BNF Firefly DC16 Nano Baby V2.0 HD 1S 1.6″ Deadcat Micro Quad w/ HDZero Whoop Lite & Nano Lite Cam – ELRS 2.4 GHz
• 4x 1608 -3 40mm 1.5mm shaft
• 2x TPU battery mount
• 1x hardware screws set
• 4x Prop guards